8
Configuration
Enter the router IP address (defaults below) into your browser and hit “Enter”.
Router Mode : 192.168.1.1
Access Point & WiFi Access Point Mode : 192.168.1.254
4. Select “WAN Interface” is Ethernet Port. Select your “WAN Access Type” according to your Internet source,
and enter the username/password. Then, you can start to setup the wireless encryption.
1. Open IE browser, type IP 192.168.1.1(P1), or open
“My Network Place”, and click SAPIDO_GR-1733 (P2).
(P1)
192.168.1.1
3. Please confirm the “Operation Mode” is default Router
Mode, and select “One Button Setup”(P4) on the left menu.
Connecting this Router to a Cable/DSL Modem
：
It can be configured without Internet.
2. Fill in default Username and Password
to login(P3).
(P3)
admin
admin
(P4)
(P2)
SAPIDO_GR-1733
Logging Into Your Router :
Enter Login Information (default below) and click “Login”.
Username : admin / Password : admin
5. After the setting is finished, you should see a “change successful” page with a countdown. When the countdown
is completed, your wireless network and security will be active, and you should be able to login immediately with
the new password. However, if an error message shows up, please refresh the page and it will go back to the
entering page. Afterwards, you can access Internet.
To Next Page
Loading...
Need help?
General