20
1. Press
the WPS button on the 11N product that you would like to connect till the WPS LED starts to flash.
2. Press the WPS button on the SAPIDO router till the WIRELESS/WPS LED turns to reddish orange. Then
the
WiFi AP setup is done.
It can be configured without Internet.
1. Open IE browser, type IP 192.168.1.1(P1), or open
“My Network Place”, and click SAPIDO_GR-1733(P2).
(P1)
192.168.1.1
3. Choose “Operation Mode”(P4).
2. Fill in default Username and Password to
login(P3).
admin
admin
(P3)
Connecting to Another WiFi network to extend the Signal :
If the network you would like to connect is an 11N product with WPS feature, you may complete the WiFi
AP setup with the WPS button.
Via WPS Button
4. Select your “Operation Mode” is WiFi AP and click
“Apply Change”. According to the following steps.
(P2)
SAPIDO_GR-1733
If ADSL/Fiber/Cable is connected to a wireless router, connect the wireless router to your
SAPIDO router, then you can extend wireless signals and share Internet to multiple devices.
Via Program
(P4)
5. After the setting is finished, you should see a “change successful”
page with a countdown. When the countdown is completed, your wireless network and security will be active, and
you should be able to login immediately with the new password. However, if an error message shows up, please
refresh the page and it will go back to the entering page. Afterwards, you can access Internet.
To Next Page
Loading...
Need help?
General