22
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Wall Mount Installation - Round Aluminum or Wood Clock - Locally Powered
7) Place the mounting piece on the wall above the
gang box so that the bottom centered hole on the
piece overlaps the top hole on the gang box. Insert
a #6-32x1 screw through the bottom centered hole
and into the top hole of the gang box.
8) Temporarily attach the clock to the mounting
piece (see step 11), use the pencil to mark the
location of the hole at the top of the release lever,
and remove the clock again (see step 13). Remove
the mounting piece and make a hole at the location
you just marked with the 1/8 inch drill bit. When
finished, reattach the mounting piece.
10) Lay any excess wiring across the strain relief
base, then attach the strain relief to the clock with
the two #6-19x7/16 screws. The strain relief should
be tight enough to prevent the wire from sliding.
9) First remove the gearbox pin, then attach the
power connector to the port on the movement.
1
2
To Next Page
Loading...
