Sapling SAL Series - Legacy Movement - Battery Powered

88
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Legacy Movement - Battery Powered
1) On the clock movement, press the battery cover
locking tab and pull the cover away from the clock
to access the battery pack.
Earlier versions of the clock use a different
movement design (pictured below). This section
explains how to insert new batteries into the
original movement.
2) First remove the gearbox pin, then insert the
batteries into the clock. If the clock is within range
of a powered transmitter, the hands should begin to
move within a minute.
1
2
3) Place the cover back onto the battery pack. You
should hear a snapping noise as the locking tab
engages. Use the #4x5/16 Screw screw to prevent
the cover from opening again.