60
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Flag Mount Installation - Square Clock - Locally Powered
12) Attach the base of the pole to the mounting plate, so that the lip is on the top of the base, and the
holes for the screws are on the bottom of the base. Hang the base on the mounting plate, attach the
wires from the bottom of the pole to the wires in the gang box, then screw the other side of the base
onto the mounting plate using the two black screws you set aside before.
13) Attach the power wires from your kit to the
wires you threaded through the pole.
• Attach the Hot wire to the connector’s black wire.
• Attach the Common wire to the connector’s
white wire.
• Attach the Ground wire to the connector’s
green wire.
Consult the diagram on the left for additional help.
For 24V power use the ORANGE and YELLOW wires
For 110V power use the BLACK and WHITE wires
Black
White
Black
White
Power
Common
CLOCK 1
Gang
Box
Green
Green
Ground
CEILINGWALL
1
2
1
2
To Next Page
Loading...
