Purpose
With this application, you can configure
the balance to perform certain functions
(such as automatic printout of values, store
value in totalization memory) at a given
time or after a set interval.
You can use this application in combina-
tion with any program chosen from Appli-
cation 1 (such as counting, weighing in
percent) and one from Application 3 (such
as totalizing, formulation) as well as with
the extra functions.
97
Features
– Time-controlled activation of balance
functions:
– one time only, at a given time
(
Setting= is displayed in the
text line)
– repeatedly, at given intervals
(
Interval= is displayed in
the text line before the function is
started, and
Repeat = is displayed after the
function has been started)
– Functions that can be time-controlled
include:
– Acoustic signal (beep)
– Lock in readout
– Automatic printout of values
– Store values for totalizing,
formulation or statistics
– Print time in addition to
weight value
– Store value depending on
the stability parameter
– Tare the balance after printout
of weight values
– Press the corresponding soft key to
cancel time-controlled functions
Factory Settings of the Parameters
Function after time interval:
Automatic printout
of values
Automatic function restart: On
Storage mode:
Without stability
Print then tare: On
Soft Key Functions
Stop Stop the application
Quit Confirm performed function
(e.g., “Lock in readout” or
“Beep”)
Interv Store input interval for
time-controlled functions
Set. Store input time for one-time
performance of function
Printout for Time-Controlled Functions
If the “Automatic printout of values”
parameter is set, the time and weight (or
other value) are printed out.
Time : 10:15:00
N +150.00000 g
Time: Time that the values were stored
N: Net weight
Time-Controlled Functions
K
To Next Page
Loading...
