Sartorius ME235P - Configuring a Printout; Application-defined; Automatic output of displayed value; Output to interface ports

Factory Settings of the Parameters
Device parameters: Interfaces:
Serial communication:
SBI
Serial printer: YDP03
Printout: Output to interface ports: serial
communicaton (PERIPHERALS):
Application-defined output
Printout: Output to interface ports:
Serial printer (PRINTER):
Application-
defined output
126
Preparation
Configuring the Interfaces
● Turn on the balance: press e
> The Sartorius logo is displayed; a self-test is performed
● Configure the interfaces : press s
● Select Device parameters: press the q soft key, then the O
● Select Interfaces: press the q soft key 5 x, then the O soft key once
Interfaces Serial
ο SBI
communication XBPI
(PERIPHERALS)
Serial printer YDP01IS
(PRINTER) YDP02
ο YDP03
YDP01IS Label
YDP02
YDP02IS Label
Universal
YDP04IS
YDP04IS Label
ο = factory setting
see also the “Application Parameters (Overview)” in the chapter entitled
“Configuring the Balance”
● Save settings and exit the Setup menu: press the oo soft key