Additional Functions
In addition to the functions:
– alphanumeric input
– taring (not during
alphanumeric input)
– printing
you can also access the following func-
tions from the weighing application:
– calibration/adjustment (not during
alphanumeric input)
– setup
– turning off the balance
41
Calibration
● Press the
Cal soft key
> See the section on “Calibration/Adjust-
ment” for further instructions
Setup
● Press s
> See the chapter entitled “Configuring
the Balance” for further instructions
Turning Off the Balance
● Press e
> The balance shuts off
> The display goes blank
Examples
Example W1: Simple weighing
Step Press key(s) (or follow instructions) Display/Output
1. If necessary, tare the balance t
(S symbol: balance is tared
– verified balances only)
2. Enter sample ID see example W2
3. Determine sample weight Place sample on balance
(example)
4. Print weight
p/r
For Service:
Using Verified Balances as Legal
Measuring Instruments in the EU.
This balance is not allowed to be used
for weighing goods intended for direct
sale to the public. The type-approval
certificate for verification applies only
to non-automatic weighing instru-
ments; for operation with or without
auxiliary measuring devices, you must
comply with the regulations of your
country applicable to the place of
installation of your balance.
● Before using the balance as a legal
measuring instrument, calibrate and
adjust it at the place of use: see the
section on “Calibration, Adjustment” in
this chapter
$ The temperature range (°C) indicated on
the verification label may not be
exceeded during operation.
Example:
BE BK 100
k 0…+40 °
To Next Page
Loading...