10
3. Clear existing buffers when doing a new 2- or
3-point standardization. Use the Setup button.
Also use the Setup button to select the individual
sets of buffers. (See page 13.)
4. Press Standardize. The meter recognizes the buffer
and flashes a buffer icon. When the signal is stable,
the buffer is entered. By pressing ENTER you can
also enter the current buffer directly.
5. The meter displays the slope of the electrode as
100.0%. On entering a second or third buffer,
the meter performs a diagnostic check on the
electrode and displays the slope. (See step 7 ff.)
[Standardize]
To Next Page
Loading...
