13
Using Setup
The Setup button lets you clear all the standardiza-
tion data that you have entered, review calibration
information, or select the buffer set that you want.
You can escape the setup mode at any time by
pressing pH/mV.
1. Press Setup once to clear all buffers you have
entered. If you are sure you want to clear the
buffers, press Enter. The meter clears all buffers
and returns to Measuring.
2. Press Setup again to show electrode performance,
slope and the first and second calibration points.
The two buffer values will also be displayed.
3. Pressing Setup again shows the electrode slope
between the second and third buffers (if three
buffers have been entered) and shows the second
and third buffer icons.
[Setup]
[Enter]
2+ [Setup]
To Next Page
Loading...
