Important Note to Users
!
Make sure to carefully read and follow sections
marked with this symbol – they contain important
safety instructions.
If you turn off the scale while it is running on power
supplied by the battery pack and the external AC
adapter YRB06Z is not plugged in for recharging,
make sure to turn off the battery pack as well.
Note:
(For QC 34 and QC 64 models only)
Transport Locking Device
Do not remove the transport locking device until the
scale is set up at the place of installation. Remove the
load plate.
The transport locking devices (yellow) are located on
the short sides of the scale.
Remove the transport locking devices (unfasten
them using an Allen wrench) before initially operating
the scale.
Verification Mark (Seal)
The law requires that a verified scale be sealed
with a verification mark. The verification marks
(seals) on a verified QC scale indicate that this scale
may only be opened and serviced by authorized
technicians, to ensure reliable and trouble-free
operation and to avoid forfeiture of the warranty
coverage. If a verification mark (seal) is damaged,
please observe the national laws and regulations
in effect at the place of installation.
1–4
To Next Page
Loading...
Need help?
General