Clean the outside of the machine.
Make sure the throttle trigger lock and
the throttle function correctly from a
safety point of view.
Check that the engine switch works
correctly.
Check that the blades do not move when
the engine is idling or when the choke is
in the start throttle position.
Check that the blades are undamaged
and show no signs of cracking or other
damage. Replace the blades if
necessary.
Check that the blade guard is not
damaged or distorted. Replace the blade
guard if it is bent or damaged.
Clean the air filter. Replace if necessary.
Check that nuts and screws are tight.
Check that there are no fuel leaks from
the engine, tank or fuel lines.
Check the starter and starter cord.
Clean the outside of the spark plug.
Remove it and check the electrode gap.
Adjust the gap to 0.6-0.7 mm or replace
the spark plug. Check that the spark plug
is fitted with a spark plug cap.
Clean the machine’s cooling system.
To Next Page
Loading...
General