To Next Page

To Previous Page

Setting the Heating Schedule Programs

The condition for setting the Heating schedule is that the Heating programs are turned on (it is

turned off by default) in the advanced settings.

Before proceeding, check the advanced thermostat settings. Depending on the set advanced

thermostat settings, you can set on how the schedule program works. In advanced settings, you can

set your schedule for 7 days (each day) or just turn it off.

The Heating schedule can be easily edited via the main editing menu - the thermostat must be

turned on, then hold (5 seconds) the middle menu button (button description 3). Now you’re in the

program editing menu.

When you’re in the Heating schedule programs editing menu, you’ll see on the right side of the

screen a blinking icon (sun, moon, house…) which shows for which program switch you’re currently

editing the program. Also at the top of the screen, the day which you’re editing starts to blink. That

means that you’re editing for the selected day.

You change the values by pressing the  and buttons and go to the next setting with the middle

menu button (button description 3). All the settings will be automaticly saved if you don’t press any

button for more than 10 seconds.

First you have to select for which day you’ll be setting the schedule. When you select the day, press

the menu button and then you’ll proceed to setting the time of when this schedule will start. When

you’re done setting the time, press the middle menu button and you’ll be setting the temperature for

that schedule. Set the desired temperature and again press the menu button. Now you’re done

setting the settings for the first Heating schedule switch of the program. Now a different icon on the

right should blink, which indicates that you’re editing for the next Heating program switch.

You can take a look at example of predefined Heating schedule programs on page 2.

All settings of heating schedule programs can be reset to factory defaults by holding the

 button

(button description 2) for 3 seconds while editing the programs. Screen will show and blink dEF.

Saswell SAS922-7 User Manual

Questions and Answers: