conditions. Select 1 for NO backlight display. Select 2 for the backlight
to come on for approximately 30 seconds when any button of the
thermostat is touched. Select 3 for the backlight to remain on
continuously.
NOTE: When operated from batteries only, the LCD display
backlight will be illuminated less than 5 seconds after each button
pressed ,when backlight option are set to 2) or 3). Options 2) & 3)
will operate the same when terminal “C” is not connected.
5. Select filter replacement run time
The thermostat will display the Filter Alarm after a set time of operation.
This is a reminder to change or clean your air filter. This time can be
set from 0 to 12 months in 1 month increments. Selection of 00 WILL
To Next Page
Loading...
