2. When the (FA)st cooling cycle rate is selected in the configuration
menu, (see configuration menu item 2), the thermostat will call for cooling at
0.5ºF (0.5ºC) above set-point, and turn off set point. When the (SL)ow cool
cycle rate is selected, the thermostat will call for cooling at 1.5ºF (1.5ºC) above
set-point, and turn off at set-point. When the thermostat calls for cooling, the
display will show COOL On. If the COOL On display is flashing, the
compressor lockout feature is operating. mode. (Note: See Configuration
If all functions operate properly, the thermostat is installed correctly.
If your thermostat was pre-installed, the batteries may be in place. If the
battery icon on the display is flashing, it indicates that the batteries need to
be replaced. When the thermostat is powered only by battery, the battery icon
will flash for approximately 2 months before the batteries are expected to
To Next Page
Loading...
Need help?
General
