6 AXD-200 SATEL
ATD-200
The detector reports alarm when it registers a temperature higher / lower than the predefined
threshold. The detector allows you to program two critical temperature thresholds: low (L)
and high (H). The detector will alert of the threshold being exceeded if the temperature:
• drops below the value preprogrammed for the low (L) threshold,
• rises above the value preprogrammed for the high (H) threshold.
Information about the current temperature is sent when the detector connects to the
controller / control panel.
AFD-200
The detector reports alarm approximately 5 seconds after the water level reaches the height
at which the probe is installed. The detector reports end of flooding a few seconds after the
water level drops below the height at which the probe is installed.
ATX-220
The expander reports alarm after opening the NC type input.
ATX-230
The expander reports alarm:
• after opening the NC type input,
• after registering a specific number of pulses within a defined time period by the roller
shutter input,
• after opening the roller shutter input (tamper alarm).
Operating modes
Active – information about each alarm is sent immediately.
Passive – only information about tamper alarm is sent immediately. This operating mode
prolongs the battery life.
The operating mode is turned on remotely. If the device is used in the INTEGRA / VERSA /
PERFECTA 64 M alarm system, the operating mode may depend on the partition state
(partition disarmed – passive mode; partition armed – active mode). For more information,
refer to the ABAX 2 / ABAX controller manual / the INTEGRA 128-WRL control panel
manual.
Energy saving mode (ECO)
If you want to prolong the battery life, you can enable in the device the ECO option. When the
ECO option is enabled, the periodical communication takes place every 3 minutes. Thus the
To Next Page
Loading...
