38
System description and installation
CA-64 SATEL
Programming by telephone
When restart with restoration of factory settings is already made for the control panel,
the telephone number of service computer must be programmed to start
programming. Proceed as follows:
1. Enter the service mode,
2. Select position “TS Configuration”,
3. Select position “Computer telephone”,
4. Program the computer telephone number (0..9 – digits, B – triggering to pulse
picking, C – triggering to the tone dialling, D – waiting for additional signal,
E – 3-second pause, F – 10-second pause).
NOTE:
Do not program letter “A” for a telephone number (A is a marker of number
end), which is automatically added after last digit.
Start of communication with the computer via telephone line is ensured by “Start
DWNL-TEL” function. This function is accessible in the user functions menu for the
administrator and the service (if the service personnel are authorized to start
downloading).
To Next Page
Loading...
