13
8. Warnings for low battery
When the batteries are exhausted, mark will blink. Place the batteries with new ones.
Otherwise, measured value may display incorrectly.
9. Error Message
If an error occurs, one of the error codes below will be shown on the temperature display section.
Measured value exceeds the Hi or Lo
value.
Bring the value within the measuring range.
Measured value is higher than display
range
Measured value is lower than display
range
Internal processing is abnormal
. Remove batteries. Then load batteries again
after leave it for a while
. Replace the batteries to new ones
A sensor signal is abnormal.
Turn the power off once. Connect the probe
securely and turn the power on.
Probe is not connected or probe is
failure.
This error code is displayed when power is
turned on without connecting the probe.
Connect the probe.
. If the error code is displayed although the
probe has been connected, stop using it and
contact us or the dealer.
If the problem still persists, please contact us or the store where you purchased this product.
To Next Page
Loading...