5
⚫ Sensing Area
① Temperature measuring area
② Laser projection window:
Do not look into the laser beam
③ Laser projection window (for SK-8140 only)
Do not look into the laser beam
Note: Even with the lens cover closed, laser can
be projected if the button is pushed.
Please take an extra caution while handling.
⚫ LCD Display
① Emissivity Mark: This mark appears when
emissivity is set.
② High Temperature Alarm: This mark and
measured value blink with a buzzer when the
measured temperature exceeds the set upper
threshold.
③ Low Temperature Alarm: This mark and
measured value blink with a buzzer when the
measured temperature exceeds the set lower
threshold.
④ Low-Battery Mark: This mark appears when the battery consumption is low.
⑤ Measurement Value: In three digits
⑥ This mark appears when the button is pressed and the laser beam is projected.
⑦ PEAK: This mark appears while in ‘PEAK’ measuring mode.
⑧ VALLEY: This mark appears while in ‘VALLEY’ measuring mode.
⑨ ºC: The temperature unit is Celsius (temperature unit can be switched to Fahrenheit)
To Next Page
Loading...