PARTS LIST
OPERATION & INSTALLATION
DISPENSER
OPERATION
1. The customer takes a number from the dispenser;
this number will indicate the customer’s spot in the
queue
2. The customer will be notified of their turn when
their number is displayed on the indicator
3. The associate will use the wireless remote to
advance the display by pressing the (+) button or to
turn the display back by pressing the (-) button
4. If the associate wishes to advance the display by
tens they will press and hold the (+) button
MOUNTING
The dispenser can be mounted to either the wall or stand
WALL MOUNTING
1. Measure and mark the
mounting holes on the wall
using the dispenser
mounting bracket as a
template (Figure 1)
2. Drill holes using a 3/16” to
5/16” drill bit
3. Use the wall anchors if
mounting the dispenser to a
surface other than solid
wood
4. Position the sign and
dispenser mounting bracket
over the holes in the wall
and fasten with two slotted
screws (Figure 2)
5. Snap the dispenser into the
mounting bracket (Figure 3)
Figure 1
Figure 2 Figure 3
STAND MOUNTING
1. Position the mounting stand in the desired
location on a countertop
2. Align the holes in the sign and the mounting
bracket with the holes in the post. Push the two
large slotted bolts through bracket and sign and
secure with the provided nuts (Figure 4)
3. Snap the dispenser into the mounting bracket
(Figure 3)
Figure 4
LOADING DISPENSER
1. Pull the locking bar down to open the dispenser
2. Place the roll of tickets in the dispenser, making
sure the numbers are facing up and the roll out
from the bottom (Figure 5)
3. Pull the end of the roll of tickets through the
dispenser and securely shut the dispenser by
snapping the locking bar back into place
Figure 5
www.satoamerica.com
To Next Page
Loading...