OPERATION & INSTALLATION DISPLAY CONT.
SET-UP
SOUND & TONE VOLUME
Use a mini flathead screwdriver to change the tone and
volume switches on back of the display (Figure 12)
TONE
No Sound: 1-OFF1 2-OFF
Single Tone: 1-OFF 2-ON
Double Tone: 1-ON 2-OFF
Triple Tone: 1-ON 2-ON
VOLUME
Low Volume: 3-OFF 4-OFF
Medium Volume: 3-ON 4-OFF
High Volume: 3-OFF 4-ON
Highest Volume: 3-ON 4-ON
Figure 12
DISPLAY START-UP
Once powered on, the display will show a number of
messages upon start-up (Figure13)
DISPLAY SHOWS
Program Version: “P-”, then number
TOM-Net Address: “ad’, then 51 or 21
Last Number Displayed When The Power Has Been
Disconnected: Number, (00 if first-time start-up)
Error Message if Displayed is Set as a Duplicate Master: “Ed”
Figure 13
OPTIONAL
DISPLAY SET-UP
• To enter setup options, make sure the
display is unplugged.
• Hold down (+) on the wireless push button
and plug the display back in.
• Release (+) when the display reads “UP”
SET DISPLAY UPDATE DELAY:
• Display shows “UP” followed by the current
delay time in seconds, (ex. “00”). Press (+) on
the wireless push button to increase the delay
one second at time
• After three without pushing the button, the
set display sleep time “SL” appears
SET DISPLAY SLEEP TIME:
• Display shows “SL” followed by the current
delay time in minutes. (The display shits off
after a set periods of the time with no button
pushes.) Press (+) on the wireless push
button to increase the delay before the
display goes into sleep mode one minute at a
time
• After three seconds without pushing the
button the set display flashes and “FL”
appears
SET DISPLAY FLASHES WHEN NUMBER CHANGES:
• Display shows “FL” followed by the current
setting showing number of flashes. Presses (+)
on the wireless push button to increase the
number of times the display will flash when the
number changes one flash at a time
After three seconds without pushing the button,
the display shows “CS” and saves the new settings
to memory
Figure 14
www.satoamerica.com
To Next Page
Loading...