AM-FM Radio
Playing the Radio
PUSH ON (Power): Push this knob to turn the system
on and off.
VOL (Volume): Turn this knob to increase or to
decrease the volume.
RCL (Recall): Press this button to switch the display
between the radio station frequency and the time.
When the ignition is off, press this button to display
the time.
Finding a Station
AM FM: Press this button to switch between FM1,
FM2, or AM. The display will show the selection.
R TUNE Q: Press either arrow to select radio
stations.
R SEEK Q: Press and hold the up or the down
arrow to go to the next or to the previous station and
stay there.
The radio will only seek stations with a strong signal
that are in the selected band.
SCN (Scan): Press this button to scan stations. The
radio will go to a station, play for a few seconds, then go
on to the next station. Press this button again to stop
scanning.
The radio will only scan stations with a strong signal
that are in the selected band.
3-45
To Next Page
Loading...
Need help?
General
