Removing the Flat Tire and
Installing the Spare Tire
1. If your vehicle has plastic wheel covers, use
the wheel wrench to loosen the plastic wheel
nut caps.
Once you have loosened the plastic wheel nut
caps with the wheel wrench, you can finish
loosening them with your fingers. The plastic
nut caps do not come off. Using the flat
end of the wheel wrench, pry along the edge
of the wheel cover until it comes off.
If your vehicle has aluminum wheels, first
remove the center cap by pulling it out with the
wheel wrench.
2. Use the wheel wrench to loosen all the wheel
nuts. Do not remove them yet.
Notice: Make sure that the jack lift head is in
the correct position or you may damage
your vehicle. The repairs would not be covered
by your warranty.
356
To Next Page
Loading...
