Replacing Restraint System Parts
After a Crash
{CAUTION:
A crash can damage the restraint systems
in your vehicle. A damaged restraint
system may not properly protect the
person using it, resulting in serious injury
or even death in a crash. To help make
sure your restraint systems are working
properly after a crash, have them inspected
and any necessary replacements made as
soon as possible.
If you have had a crash, do you need new belts?
After a very minor collision, nothing may be
necessary. But if the belts were stretched, as they
would be if worn during a more severe crash,
then you need new parts.
If belts are cut or damaged, replace them. Collision
damage also may mean you will need to have
safety belt or seat parts repaired or replaced. New
parts and repairs may be necessary even if the belt
was not being used at the time of the collision.
If an airbag inflates, you will need to replace airbag
system parts. See the part on the airbag system
earlier in this section.
If the frontal airbags inflate, you will also need to
replace the driver’s and passenger’s safety belt
retractor assembly. Be sure to do so. Then the new
retractor assembly will be there to help protect you
in a collision.
After a crash you may need to replace the driver
and front passenger’s safety belt retractor
assemblies, even if the frontal airbags have not
deployed. The driver and front passenger’s safety
belt retractor assemblies contain the safety belt
pretensioners. Have your safety belt pretensioners
checked if your vehicle has been in a collision, or if
your airbag readiness light stays on after you start
your vehicle or while you are driving. See Airbag
Readiness Light on page 130.
57
To Next Page
Loading...
Need help?
General
