5. Pull the convertible top forward by firmly gripping the
side edge (B) and applying a brisk upward and
forward motion to get the top in the full-up position.
6. Pull the front edge (A) of the convertible top forward
from the outside of the vehicle, or push the front
edge (A) of the convertible top forward from
the inside of the vehicle.
7. Turn the top front latch handle clockwise to latch
the convertible top.
8. Close the trunk (D) by pressing down from the rear
center of it with a swift, firm motion.
9. At the rear edge of the convertible top, press down
on the two buttresses (C) to latch them into the top
of the trunk.
A clear Mylar
®
protective film has been installed at the
factory on the trunk lid surface under the convertible
top buttresses. This film is designed to help prevent
paint damage to the trunk lid. Do not remove this
protective film. It is intended to remain permanently
affixed to the trunk lid surface.
2-37
To Next Page
Loading...
Need help?
General
