3. Remove the two taillamp hex nut
covers.
4. Remove the two hex nuts
holding the taillamp assembly in
place.
5. Pull out the taillamp assembly.
6. Turn the bulb socket
counterclockwise and pull it
straight out to remove it.
7. Replace the old bulb with a
new one.
8. Reverse Steps 3 through 6 to
reinstall the taillamp assembly.
When reinstalling the taillamp
assembly, make sure the plastic
pin on the taillamp assembly
lines up and is inserted correctly
into the opening of the vehicle.
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding
each of the license plate lamps
to the liftgate trim.
2. Turn and pull the license plate
lamp forward through the lift
gate trim opening.
3. Turn the bulb socket
counterclockwise and pull the
bulb straight out of the socket.
4. Install the new bulb.
5. Reverse steps1–3toreinstall
the license plate lamp.
Replacement Bulbs
Exterior Lamp
Bulb
Number
License Plate Lamp 194
Rear Sidemarker
Lamp
194
Rear Turn Signal
and Taillamps
3157K
For replacement bulbs not listed
here, contact your dealer/retailer.
Service and Appearance Care 5-37
To Next Page
Loading...
Need help?
General
