28
1. Check the electric voltage before you operate the boiler.
2. Tele-room controller can be adapted to voltage DC 24-31V form the main controller
of boiler.
3. Make sure to connect the electric port properly. One is far room controller , the other is
for telephone.
Check point for safety
1. Fix the room controller on the wall of room or living room. The height is about 1.5m.
2. Fix on the properly spot to sense the room temperature.
3. Avoid to x near the heater or under the sun light, this can cause the torsion of the
case and do a harm to the electric parts inside the case.
4. Avoid to x in the place there is dirty, humid, this can do harm to the electric parts
inside the case.
Check point for fixing
1. You had better take care to prevent the metallic parts (Needle, Coin)
or in ammables (Paper, Match stick) form entering into the air vent hole of the case.
This can make a short-circuit or re.
2. Do not open the case, and treat your self.
3. Be careful the power line not to exposed in the room.
4. Keep out form the volatiles (Thinner, Benzene, Solvent…)
5. Before you polish the room controller , plug the power cord out and use a smooth cloth.
Check point for usage
Description & Function
£Run (Normal operating)
¤Hot w+ater supply
¥Heating mode
¦Boiler stop
§Check (Operating error)
¨Power on/o
Signal lamp
©7HPSHUDWXUH(UURUGLVSOD\
ª%RLOHUZDWHUWHPS
FRQWURONQRE
«3RZHU5HVHWVZLWFK
Operation & Sensor
To Next Page
Loading...