Step 10
å
Carefully turn your unit over onto its front edges. Lay the
BACKS (J and K) over your unit.
å
Make equal margins along all four edges of the BACKS (J
and K). Push on opposite corners of your unit if needed to
make it "square".
å
Fasten the BACKS (J and K) to your unit using the NAILS (RR).
å
NOTE: Be sure to tap NAILS into the holes that line up over
the UPRIGHT (D).
å
NOTE: Perforations have been provided for access through
the BACK. Carefully cut out the holes needed.
408761 www.sauder.com/servicesPage 14
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
Unfi nished surface
These holes must line up
over the UPRIGHT (D).
NAIL
(44 used in this step)
RR
Unfi nished
surface
Cut-out
J
K
To Next Page
Loading...
