Step 11
408761www.sauder.com/services
Page 15
VIEW THE T-LOCK BOX VIDEO
å
Fasten the LARGE DRAWER BACK (D78) to the LARGE DRAWER
SIDES (D14 and D15). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the groove of the
LARGE DRAWER BACK (D78).
å
Repeat this step for the remaining drawer using the LARGE
DRAWER BOTTOM (D707).
12
3
å
Insert the LARGE DRAWER SIDES (D14 and D15)
at an angle into the slot at each end of the LARGE
DRAWER FRONT (O).
å
Slide the DRAWER BOTTOM (D716) into the grooves in
the LARGE DRAWER SIDES (D14 and D15) and LARGE
DRAWER FRONT (O).
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
Groove
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
D14
D15
D716
D716
D14
D15
D78
D15
O
O
Unfi nished
surface
With the palm of
your hand, tap the
DRAWER BOTTOM
down into the groove.
D14
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
30S
To Next Page
Loading...
