Step 19
408995 www.sauder.com/servicesPage 24
VIEW THE T-LOCK BOX VIDEO
å
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D28 and D29). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D707) inserts into the groove of the DRAWER BACK (D78).
12
3
å
Insert the DRAWER SIDES (D28 and D29) at an angle
into the slot at each end of the DRAWER FRONT (M).
å
Slide the DRAWER BOTTOM (D707) into the grooves in the
DRAWER SIDES (D28 and D29) and DRAWER FRONT (M).
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
Groove
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
D28
D29
D707
D78
M
Unfi nished
surface
D28
D29
M
D707
D28
D29
With the palm of
your hand, tap the
DRAWER BOTTOM
down into the groove.
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
30S
To Next Page
Loading...
