Sauder 419954 - Step 6

Step 6
419954 www.sauder.com/servicesPae 10
Fill the holes 1/4 to 1/2 full with GLUE.
Inspect the parts thorouhly before
assemblin. Disassembly of lued
parts is extremely di cult.
Caution
!
54M
15F
å
First, fi ll two holes in the ENDS (A and B) 1/4 to 1/2 full with GLUE (54M). Then,
insert two WOOD DOWELS (15F) into the holes. Wipe away the excess GLUE.
å
NOTE: Be sure to position the parts exactly as shown.
å
Now, fi ll the holes in the FRONT LEGS (H and P) 1/4 to 1/2 full with GLUE (54M).
å
Fasten the FRONT LEGS (H and P) to the ENDS (A and B). Tihten six
HIDDEN CAMS.
å
NOTE: Be sure the WOOD DOWELS in the ENDS insert into the FRONT LEGS.
Wipe away the excess GLUE.
15F
A
B
P
H
These surfaces
should be even.
These surfaces
should be even.
Surface with
TWIST-LOCK®
FASTENERS
Surface with
TWIST-LOCK®
FASTENERS
Ede with
TWIST-LOCK®
FASTENERS
Ede with
TWIST-LOCK®
FASTENERS
1
2
End without hole
End with hole