Sauder 419954 - Step 5

Step 5
419954www.sauder.com/services
Pae 9
å
Turn three BLACK 9/16" FLAT HEAD SCREWS (32S) into the
MODESTY PANEL (G) until the shoulders of the SCREWS rest on
the surface of the MODESTY PANEL.
å
NOTE: Do not overtihten the SCREWS.
å
Slide a MODESTY PANEL MOLDING (S) onto the MODESTY
PANEL (G). Line up the roove in the MOLDING over the heads of
the SCREWS in the MODESTY PANEL.
å
NOTE: If the MOLDING comes up o of the SCREWS, remove it
and slide it on aain. The MOLDING should be centered
over the MODESTY PANEL.
å
Turn the MODESTY PANEL (G) over and
repeat this step to the other surface
of the MODESTY PANEL.
Shoulder
Apply pressure with your hands as you
uide the MOLDING over the SCREWS
and onto the MODESTY PANEL.
S
G
S
G
S
Surface with
TWIST-LOCK®
FASTENERS
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
32S
32S
Surface
without
TWIST-LOCK®
FASTENERS