Sauder 419954 - Step 22

Step 22
VIEW THE T-LOCK BOX VIDEO
å
Fasten the LARGE DRAWER BACK (D78) to the LARGE DRAWER SIDES (D28
and D29). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the LARGE DRAWER BOTTOM (D707) inserts into the roove
of the LARGE DRAWER BACK (D78).
å
Repeat this step for the other LARGE drawer.
12
3
å
Insert the LARGE DRAWER SIDES (D28 and D29)
at an anle into the slot at each end of the LARGE
DRAWER FRONT (W).
å
Slide the LARGE DRAWER BOTTOM (D707) into the
rooves in the LARGE DRAWER SIDES (D28 and D29)
and LARGE DRAWER FRONT (W).
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
Groove
30S
Start each screw a few turns before
completely tihtenin any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT roove.
D28
D29
D707
D707
D28
D29
D78
D29
W
W
Unfi nished
surface
D28
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK roove.
With the palm of your hand,
tap the DRAWER BOTTOM
down into the roove.
419954 www.sauder.com/servicesPae 26