å
Slide the FEET (31E and 32E) into the notches in the SKIRTS (Q and R).
å
Use a hammer to drive a PROPEL NUT (14M) into the holes in the
FEET (31E and 32E). Now, turn an ADJUSTABLE GLIDE (18E) into each
PROPEL NUT as shown in the upper diagram.
å
Fasten the SKIRTS (Q and R) to the BOTTOM (F2). Use four BLACK
9/16" WAFER HEAD SCREWS (33S) through the FEET and into the
BOTTOM as shown in the lower diagram.
å
NOTE: You should start each SCREW a few
turns before completely tightening
any of them.
Step 7
This hole must be here.
18E
14M
(4 used)
Q
Q
R
R
R
R
32E
32E
31E
31E
F2
BLACK 9/16" WAFER HEAD SCREW
(4 used for the FEET)
33S
422427www.sauder.com/services
Page 13
LARGE DOOR ON LEFT
To Next Page
Loading...
