Step
422427 www.sauder.com/servicesPage 38
Step 32
LARGE DOOR ON RIGHT
å
NOTE: Do not turn the SAFETY DRYWALL ANCHOR (61M) into a wall stud. If you prefer to
fasten the SAFETY STRAP (60M) to a wall stud, go to your local hardware store for
proper hardware.
å
INSTALLATION INSTRUCTIONS:
1. Insert the SAFETY DRYWALL ANCHOR (61M) through the WASHER (13M) and the end of
the SAFETY STRAP (60M).
2. Using a Phillips screwdriver or a hand drill, press the screw slightly onto the drywall.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
å
NOTE: Before moving your unit to a di erent location, unscrew the SAFETY DRYWALL
ANCHOR (61M) from your wall. The nylon sheath will remain behind your wall.
60M
61M
13M
To Next Page
Loading...
