å
Carefully stand your unit upright.
å
Open the FURNITURE TIPPING RESTRAINT KIT (98) and fasten the SAFETY STRAP to the TOP/BOTTOM (E). Use
the provided short screw.
å
Place your unit in its final location against a wall. Locate the center of a stud in your wall near your unit and mark it
with a pencil. Next, drill a 1/8" hole on the mark and into the stud in your wall.
å
Fasten the unit to the wall. Use the long screw through the other end of the strap and into the 1/8" hole.
å
Peel APPLIQUES from the APPLIQUE CARD (7) and stick them onto each visible SCREW head.
å
Peel the BUMPERS from the BUMPER CARD (6) onto the TOP/BOTTOMS (E) shown where they come in contact with
the DOORS (C).
Step 14
Use the short screw through the
hole in the strap and into the top
surface of the TOP/BOTTOM (E).
98
98
Electric drill with 1/8" bit
(ONLY in indicated step)
Drill 1/8" hole into
a stud in your wall.
To cover SCREWS
7
(16 used)
6
C
C
E
Page 18 www.sauder.com/service 426927
To Next Page
Loading...
