Sauder 430083 - Page 17

Step 12
F
L
A
D
E
å
Insert ten WOOD DOWELS (1) into the LEFT END (A).
å
Fasten the LEFT END (A) to the TOP (D), BOTTOM (E), BASES (G), and TOP MOLDING (P). Use seven 2" FLAT HEAD
SCREWS (12).
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
NOTE: Be sure the WOOD DOWELS in the LEFT END insert into the TOP, BOTTOM, BRACE, BASES, LARGE SHELF, and
TOP MOLDING.
å
Fasten the LARGE SHELF (F) and BRACE (L) to the LEFT END (A). Tighten three HIDDEN CAMS.
P
G
G
1
2" FLAT HEAD SCREW
(7 used in this step)
12
Surface with less holes
1
Page 17www.sauder.com/service430083
1