Step 13
å
Carefully turn your unit over onto its front edges. Unfold
the BACK (N) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (N).
Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (N) to the BRACE (L). Use four 1/2" PAN
HEAD SCREWS (14).
å
Fasten the BACK (N) to your unit using the NAILS (9).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the SHELVES (F and O).
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
Unfi nished
surface
These holes must line up
over the SHELVES (F and O).
NAIL
(51 used in this step)
9
8
1/2" PAN HEAD SCREW
(4 used in this step)
14
N
Page 18 www.sauder.com/service 430083
To Next Page
Loading...
