Sauder 430083 - Page 21

å
Before fastening the DOORS to your unit, be sure the
mounting screw is against the outer end of the slot as
shown in the right diagram. If it isn't, loosen the adjusting
screw and mounting screw to slide it against the end of
the slot. Then tighten the mounting screw.
å
Fasten the LEFT DOOR (H) to the LEFT END (A). Use the
SCREWS in the HINGES.
å
Fasten the CENTER DOOR (K) to the UPRIGHT (C). Use
the SCREWS in the HINGES.
å
Fasten the RIGHT DOOR (J) to the RIGHT END (B). Use
the SCREWS in the HINGES.
å
Fasten the PULLS (8) to the DOORS (H, J, and K). Use six
5/8" MACHINE SCREWS (13).
Step 16
H
J
K
A
B
C
17
Mounting
screw
Slot
Hinge
Adjusting
screw
Page 21www.sauder.com/service430083
5/8" MACHINE HEAD SCREW
(6 used in this step)
13
8
8