Step 19
å
1
st
- With your pencil, strike a mark through the center of the hole in the SAFETY STRAP.
å
2
nd
- Drill a 3/8" hole on the mark.
å
3
rd
- While you squeeze the wings together, gently tap the WALL ANCHOR from the FURNITURE TIPPING RESTRAINT
KIT (96) into the hole until it is even with the surface of the wall.
å
4
th
- Turn the LONG SCREW through the hole in the SAFETY STRAP and into the WALL ANCHOR.
å
NOTE: You will need to turn the LONG SCREW multiple turns to completely tighten and secure your unit to the wall.
Repeat this step fastening the remaining SAFETY STRAP if you have not already done so.
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with a damp cloth. Wipe dry.
4
th
96
1
st
Electric drill with 3/8" bit
2
nd
3
rd
Mark and drill
a 3/8" hole
into the wall.
Squeeze the wings
together and tap the
wall anchor into the
3/8" hole in the wall.
And to celebrate, why not share your success story at sauder.com or
Page 24 www.sauder.com/service 430083
To Next Page
Loading...
