Step 18
96
å
Place your unit in its fi nal location.
å
NOTE: The following instructions show your unit being fastened to a wall stud. If you are not fastening your unit to a
wall stud, go to the next step now.
å
1
st
- Locate the center of a stud in your wall near your unit and mark it with a pencil.
å
2
nd
- Drill a 1/8" hole on the mark and into the stud in your wall.
å
3
rd
-
Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY STRAP and into the 1/8" hole.
å
Repeat this step for the remaining Safety Strap or go to the next step to use the Wall Anchor.
Electric drill with 1/8" bit
2
nd
3
rd
1
st
Mark and drill
a 1/8" hole into
the wall stud.
Page 23www.sauder.com/service430083
To Next Page
Loading...
