å
Insert two WOOD DOWELS (1) into the edge of
the UPRIGHT (C).
å
Fasten the UPRIGHT (C) to the BOTTOM (E). Use two 2"
FLAT HEAD SCREWS (12).
å
NOTE: Be sure the WOOD DOWELS in the UPRIGHT
insert into the BOTTOM.
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
Step 3
C
E
Notch
1
2" FLAT HEAD SCREW
(2 used in this step)
12
Page 8 www.sauder.com/service 430083
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
To Next Page
Loading...
