Sauder Carson Forge 415520 - Page 2

å While not all parts are labeled, some of the parts will have a label or an inked letter on the ede
to help distinuish similar parts from each other. Use this part identifi cation to help identify similar parts.
A RIGHT END (1)
B LEFT END (1)
C UPRIGHT (1)
D TOP (1)
E BOTTOM (1)
F BACK (1)
G RIGHT FRONT LEG (1)
H LEFT FRONT LEG (1)
I BACK LEG (2)
J SKIRT (1)
K RIGHT TOP DRAWER (1)
L LEFT TOP DRAWER (1)
M RIGHT BOTTOM DRAWER (2)
N LEFT BOTTOM DRAWER (2)
O END MOLDING (2)
P SUPPORT FOOT (2)
Q DRAWER BRACE (6)
D12 SMALL DRAWER RIGHT SIDE (2)
D13 SMALL DRAWER LEFT SIDE (2)
D30 LARGE DRAWER RIGHT SIDE (4)
D31 LARGE DRAWER LEFT SIDE (4)
D68 LARGE DRAWER BACK (4)
D128 SMALL DRAWER BACK (2)
D733 DRAWER BOTTOM (6)
Table of Contents Assembly Tools Required
2-3
4-5
6-22
23-25
26-28
29-30
31
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Français
Español
Safety
Warranty
Hammer
Not actual size
No. 2 Phillips Screwdriver
Tip Shown Actual Size
415520 www.sauder.com/servicesPae 2
Part Identifi cation