Sauder Carson Forge Series - Assembly Tools Required for Mirror; Sauder Mirror Part Identification

Part Identifi cation
å While not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts.
A MIRROR PANEL (1)
B TOP/BOTTOM RAIL (2)
C SIDE RAIL (2)
D ATTACHMENT BAR (2)
E CHANNEL FRAME (1)
F MIRROR (1)
Table of Contents Assembly Tools Required
2
3
4-10
11-12
13-14
15
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Français
Español
Warranty
No. 2 Phillips Screwdriver
Tip Shown Actual Size
415556 www.sauder.com/servicesPage 2
A
B
C
D
E
F
B
C
D