Sauder Harbor View 417586 - Page 16

å
Lay one of the BACKS (K) over DRAWER ENDS (C and D),
and BRACE (L).
å
Make equal margins along all three edges of the
BACK (K). Push on opposite corners of your unit if needed
to make it "square".
å
Fasten the BACK (K) to your unit using the NAILS (1N).
å
NOTE: Perforations have been provided for access
through the BACK. Carefully cut out the rectangle in the
BACK for proper ventilation of your CPU.
Step 10
C
D
L
Finished
surface
K
Edge without holes
NAIL
(15 used in this step)
1N
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
417586 www.sauder.com/servicePage 16