Step 46
å
If you purchased and installed the HIDDEN WIRELESS Qi COMPATIBLE CHARGER by EGGTRONIC, plug it into an outlet
in your wall. To charge your phone, place it on the WIRELESS CHARGING SPOT STICKER. See the next page, if needed,
for troubleshooting.
å
To make adjustments to the drawers, loosen SCREW #3 in the SLIDES a 1/4 turn, then turn the CAM clockwise or counter-
clockwise. Notice how the drawer raises or lowers as you turn the CAM. The higher the screw in the oblong hole, the
higher your drawer front will be. The lower the screw, the lower the drawer front. By adjusting the drawers this way, it will
help the DRAWER FRONTS line up better when closed. Tighten the SCREW when fi nished with adjustments.
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with a damp cloth. Wipe dry.
And to celebrate, why not share your success story at sauder.com or
The higher the screw in the oblong hole,
the higher your drawer front will be. The
lower the screw, the lower the drawer front.
Loosen screw #3 a 1/4 turn, turn the cam a 1/4 turn
maximum in both the clockwise and counter-clockwise
directions to make adjustments, and then tighten screw #3.
Cam
417586www.sauder.com/service
Page 55
Scan this QR code or go to this address:
http://qr.sauder.com/?ID=2631
to leave feedback on assembly experience.
To Next Page
Loading...
