Sauter Components RDT 100 F002 - Controller Operation Modes; Technical Compliance and Data

46.100/2 RDT 100
Operation
The RDT 100 controller has software modules with fixed configurations and captive standard parameters.
When selecting the control model, the software modules are linked to (for instance) a cascade controller with
sequence output and shift. There are also modules for min./max. limitation, selection and ‘external setpoint’.
All user parameters can be stored in the optional memory for documentation purposes or for copying when
installations are similar. All parameters are captive. The sliding switch (Hand/Automatic/Service) controls the
operating modes.
Service
In this mode, the controller is matched to the control task by selecting the appropriate control model, and the
inputs and outputs and the additional functions are configured.
Automatic
Control mode with setpoint Xs1 internal or external; Xs 2 internal only.
On entering this mode, the prevailing positioning signals are adopted. They can be set manually between
0 and 100%.
Any adjustments to the control parameters are made in the ‘Hand’ mode.
Additional technical data
Radio suppression EN 55014 and 55022 Storage and transport temp. –25...+65 °C
EMC EN 50082 -1 Conformity EN 12098 and CE
RDT 100 F001 RDT 100 F002
Complies with:- Complies with:-
Directive 73/23/EEC EN 60730-1/ EN 60730-2-9 EMC directive 89/336/EEC EN 61000-6-1/ EN 61000-6-2
EMC directive 89/336/EEC EN 61000-6-1/ EN 61000-6-2 EN 61000-6-3/ EN 61000-6-4
EN 61000-6-3/ EN 61000-6-4
xi1
xi2
xi3
yp
xi4
S1
Input X
y1, Rel.1
y2, Rel.2
y3
X
S
int/ext
Functions Output Y
Memory
Option
Min
(Max)
PI/2Pt
1
A/B
PI/2Pt
2
or
or
or
or or
B06964
B06745
X
S
Enter setpoint
Setpoint limitation
min+max
Setpoint shift
A/B
Min
(Max)
PI/2Pt
P-, PI or
on/off controler
Dir. of operation
Min. or max.
selection
Dual sequence
Max. limiter
Min. limiter
Sauter Components
7146100003 S4