sauter SHG9502X - 2 Installing Your Appliance; Using the Evacuation Mode

To Next Page

To Previous Page

2 / INSTALLING YOUR APPLIANCE EN

• USING THE EVACUATION MODE

• USING THE RECYCLING MODE

If you possess an outlet to the exterior

Your hood can be connected to this outlet

than 125 mm in diameter, you must use the

recycling mode.

If you do not possess an outlet to the exterior

(pic. 2)

All of our appliances can be used in recycling

mode.

In this case, you should add an active

carbon  lter which will keep in odours. (See

Chapter 4: Changing the carbon  lter.)

— The appliance must be unplugged during installation or when any repairs or maintenance

work is being performed.

— Ensure that the network voltage corresponds to the voltage noted on the identi cation

plate located inside the hood.

— If the electrical installation at your residence requires any changes in order to hook up

your Appliance, call upon a professional electrician.

— If the hood is being used in evacuation mode, do not connect the appliance to a

combustion gas exhaust duct (boiler, chimney, etc.) or to a CMV (controlled mechanical

ventilation) system.

— Under no circumstances should the exhaust duct empty into the attic.

— Install the hood at a safe distance of at least 70 cm from an electric, gas or combined

cooking hob.