What to do if Savch SDA2-2S0.4G show overcurrent due to servomotor failure?
If your Savch Servo Drives display an overcurrent error, a possible cause is a failure of the servomotor. You can measure the resistance across the cables to check this. The resistance should be several ohms between the cables. If the motor has failed, consider replacing it.
How to check servo motor insulation fault in Savch SDA2-2S0.4G?
If you are experiencing an overcurrent issue in your Savch Servo Drives, it might be due to a servo motor insulation fault. Measure the insulation resistance to check. It should be several megaohms or over to ground.
What causes overcurrent due to encoder fault in Savch SDA2-2S0.4G?
If you are facing an overcurrent error with your Savch Servo Drives, it might be because of a current imbalance caused by an encoder fault. If this is the case, replace the servo motor.
Explains DANGER and CAUTION symbols used in the manual for safety.
Provides crucial precautions for installation, wiring, operation, test runs, and running.
Lists environmental conditions to avoid for proper servo motor drive operation.
Lists key technical specifications like input power, control modes, and interface types.
Illustrates the general wiring connections for servo motor and drive systems.
Provides detailed precautions and guidelines for correct servo motor and drive wiring.
Illustrates wiring for position, speed, and torque control modes.
Provides a comprehensive list of functional parameters, sub-modes, and examples.
Details how to check present alarms, alarm history, and their detection codes.
Explains the procedure for editing parameters using the keypad.
Guides on how to edit positioning status, stop position, and rotation speed parameters.
Lists input signals, their descriptions, and corresponding function numbers for safety.
Explains the homing motion activation, parameters, and related signals.
Details how to start movement by an interrupt traveling unit amount.
Provides detailed descriptions of basic setting parameters like control mode selection.
Provides detailed causes and solutions for common alarms like overcurrent and overvoltage.
General| Rated Power | 0.4 kW |
|---|---|
| Rated Voltage | 220 V |
| Control Mode | Position, Speed, Torque |
| Communication Interface | RS485 |
| Protection Features | Overcurrent, Overvoltage |
To Next Page
