What to do if Savch SDA2-2S0.75G Servo Drives show overcurrent due to servomotor failure?
If your Savch Servo Drives display an overcurrent error, a possible cause is a failure of the servomotor. You can measure the resistance across the cables to check this. The resistance should be several ohms between the cables. If the motor has failed, consider replacing it.
How to check servo motor insulation fault in Savch SDA2-2S0.75G Servo Drives?
If you are experiencing an overcurrent issue in your Savch Servo Drives, it might be due to a servo motor insulation fault. Measure the insulation resistance to check. It should be several megaohms or over to ground.
What causes overcurrent due to encoder fault in Savch SDA2-2S0.75G?
If you are facing an overcurrent error with your Savch Servo Drives, it might be because of a current imbalance caused by an encoder fault. If this is the case, replace the servo motor.
Essential guidelines for installation, wiring, operation, test runs, and running safety.
Illustrates standard wiring for servo motor/drive and installation notes.
Details viewing present alarms and history, including codes and meanings.
Explains pulse settings, position control, and pulsed quantity checks for precise positioning.
Guides on configuring homing patterns, parameters, and timing charts.
Lists input signals that interrupt or stop operations like Servo ON, OT, Forced Stop, Pause.
Detailed descriptions and ranges for basic parameters, including control mode selection.
Provides causes and solutions for common alarms like Overcurrent, Overspeed, Overvoltage.
General| Power | 0.75 kW |
|---|---|
| Voltage | 220V |
| Input Voltage | 220V AC |
| Communication Interface | RS485 |
| Protection Features | Overcurrent, Overvoltage, Undervoltage |
To Next Page
